Use and Care Manual
RIP / CIRCLE CUTTING (FIGURE I, J)
Ripping and circle cutting without a pencil line are easily done with
Using the screw supplied with the accessory guide, position
as
shown in figure I and thread the screw into the shoe to clamp
the fence securely.
When ripping, position as shown in figure I and slide the rip
fence under the screw from either side of the saw. Set the
cross bar at desired distance from blade and tighten screw. For
ripping, the cross bar should be down and against the straight
When circle cutting, adjust rip fence so that distance from blade
to hole in fence arm is at the desired radius and tighten screws.
Place saw so that hole in fence arm is over center of circle to be
blade into position). When saw is properly positioned, drive a
small nail through hole in fence arm. Using rip fence as a pivot
arm, begin cutting circle. For circle cutting, the cross bar should
be up, as shown in figure J.
MAKING A POCKET CUT (FIGURE K),
IT IS NOT NECESSARY TO DRILL A PILOT HOLE:
7
J
I
K
TROUBLESHOOTING
Problem Possible Cause Possible Solution
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a
service center or authorized
servicer.)
product repeatedly causes the
discontinue use immediately
and have it serviced at a
service center
or authorized servicer.)
at a
Service
of the service center nearest you or call the help line at 1-800 544-6986