Use and Care Manual

OPERATING INSTRUCTIONS
WARNING:
tool is switched off and unplugged and that the saw blade has stopped. Used saw blades
can be hot.
INSTALLING A BLADE


(Fig. A).

the blade holder as far as it will go.
NOTE: 


NOTE: 

blade holder.
REMOVING A BLADE

from the blade holder.
HEX KEY STORAGE

angle is stored in power cord holder at the rear of the jigsaw.
RIP FENCE / CIRCLE GUIDE (not provided)
This jigsaw can be equipped with a rip fence / circle
guide that will assist in cutting narrow edges from a


Set the rip fence at the desired distance from the blade

 supplied with the accessory .

edge guide is set correctly.
Adjust the edge guide as required
SETTING THE BEVEL CUTTING ANGLE
WARNING: Never use the tool when the shoe is
loose or removed.
Bevel cutting angles may be adjusted from 0° to 45°


rotated (Fig. C)

the side of the shoe (Fig. D).
Slide the base toward the rear of the jigsaw and align

angle on the shoe.
Slide the shoe forward to engage the bevel angle slot
(Fig. E).
NOTE:
between the blade and the base.
NOTE: To set the bevel angle at intermediate angles,
do not slide the base forward.

shoe in place by tightening pivot screws.

the bevel angle. Adjust the bevel angle if necessary.
5
A
14
15
18 17
16
6
C
14
15
18 17
16
6
D
14
15
18 17
16
6
E
13
11
12
B