QUICK CONNECT SYSTEM www.blackanddecker.com.
PARTS AND FEATURES figure A 1. Router attachment 2. Spindle lock button 3. Active lock-off button 4. Nut and Collet 5. Depth stop bar 6. Depth of cut scale 7. Chip shield 8. Base Not shown: Wrench A 1 3 2 5 6 7 8 4 Additional accessories are available at extra cost from your local Black & Decker dealer.
(Original instructions) ENGLISH Intended use Your Black & Decker multi-purpose tool has been designed for a wide range of DIY applications. Using the router head , this tool is intended for routing wood and wood products. This tool is intended for consumer use only. Safety instructions General power tool safety warnings : WARNING! To reduce the risk of injury, the user must read the instruction manual. General power tool safety warnings @ @ WARNING! Read all safety warnings and all instructions.
ENGLISH (Original instructions) Warning: alWayS use safety glasses. Everyday eyeglasses are NOT safety glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT: • ANSI Z87.1 eye protection (CAN/CPA Z94.3), • ANSI S12.6 (S3.19) hearing protection, • NOSH/OSHA respiratory protection.
(Original instructions) ENGLISH SyMbOlS The label on your tool may include the following symbols. The symbols and their definitions are as follows: V................... volts A ................... amperes Hz ................ hertz W .................. watts ................ alternating current min ............... minutes no.................. no load speed ............ direct current ................. Class I Construction .................. earthing terminal ................
ENGLISH (Original instructions) inStalling bitS Warning: turn the router off and remove B Spindle lock button battery from tool or disconnect plug from power source. The router is equipped with a spindle lock feature that makes changing bits easy. Lock the spindle shaft by depressing the spindle lock button as shown in figure b and use the supplied wrench to loosen (counterclockwise) the collet nut.
(Original instructions) ENGLISH 2. After obtaining the desired routing depth, release the spindle lock button. Continue turning the base until the notch under the spindle lock button (2) aligns with the next closest locking slot in the depth of cut scale (6). uSing the rOuter (fig. D & e) 1. Make sure that the material to be cut is clamped down and is stable enough to support the router during operation. 2.
Australia & New Zealand Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia Tel.1800 444 224 (Aust) or Tel.
