QUICK CONNECT SYSTEM www.blackanddecker.com.
PARTS AND FEATURES 1. 2. 3. 4. 5. 6. Oscillating tool attachment Accessory clamping lever Accessory holder Sanding platen Sand sheets Plunge cut blade 4 5 3 1 6 2 Additional accessories are available at extra cost from your local Black & Decker dealer.
(Original instructions) ENGLISH Intended use Your Black & Decker multi-purpose tool has been designed for a wide range of DIY applications. Using the oscillating tool head , this tool is intended for DIY applications such as sanding operations. It is also suitable for cutting wooden materials, plastic, gypsum, non-ferrous metals and fastening elements (e.g., unhardened nails, staples), working soft wall tiles and scraping of small surfaces. This tool is intended for consumer use only.
ENGLISH (Original instructions) • Never work in area which is soaked with a liquid, such as a solvent or water, or dampened such as newly applied wallpaper. There is an electrical shock hazard when working in such conditions with a power tool and heating of the liquid caused by scraping action may cause harmful vapors to be emitted from workpiece. • Do not use sandpaper intended for larger sanding pads.
(Original instructions) ENGLISH SyMBOLS The label on your tool may include the following symbols. The symbols and their definitions are as follows: V ..................volts A...................amperes Hz................hertz W ..................watts ................alternating current min ..............minutes no .................no load speed .............direct current ................Class I Construction ..................earthing terminal (grounded) ................safety alert symbol ..............
ENGLISH (Original instructions) INSTALLING/REMOVING ACCESSORIES This tool features a tool-free accessory changing system. This allows for faster accessory changes without the need for wrenches or hex keys like other oscillating tool systems. • Grasp the tool and squeeze the accessory clamping lever as shown in figure A. • Clean any residual debris from the tool shaft and the accessory holder.
(Original instructions) INSTALLING/REMOVING SANDING ShEETS - fIGURE D A diamond shaped platen uses a hook and loop adhesion system to attach the sanding sheets. The platen allows you to use it on large flat surfaces and tight spots or corners. • Attach the sanding platen as described under “Installing/Removing Accessories.” • Align the edges on the sanding sheet, with the edge of the sanding platen and press the sanding sheet onto the platen.
Australia & New Zealand Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia Tel.1800 444 224 (Aust) or Tel.
