4 3 5 2 1 6 9 8 7 www.blackanddecker.co.
ENGLISH (Original instructions) B A 8 C D 3 5 E 2 4 F 6 9
(Original instructions) Intended use Your BLACK+DECKER BDCHD18 - Drill, has been designed for screwdriving applications and for drilling in wood, metal and masonary. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
(Original instructions) Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated.
ENGLISH (Original instructions) Installing and removing the battery pack from the tool (fig. B) Warning! Make certain the lock-off button is engaged to prevent switch actuation before removing or installing battery. To install battery pack: u Insert battery pack into tool, until an audible click is heard (fig. B) Removing the battery pack from the tool (fig. C) u Depress the battery release button as shown in (fig. C) and pull battery pack out of tool.
ENGLISH (Original instructions) u u u u DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN RESULT. Minimize stalling on breakthrough by reducing pressure and slowly drilling through the last part of the hole. Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming. Make sure switch turns drill on and off.
(Original instructions) ENGLISH 90621477 Charger Input voltage VAC 230 Output voltage VDC 18 Current mA 200 Approx. charge time Hours 8 90590289-02 Charger EC declaration of conformity % MACHINERY DIRECTIVE BDCDC18 - Drill, Screwdriver Input voltage VAC 230 Output voltage VDC 18 Current mA 400 Black & Decker declares that these products described under Hours 3-5 "technical data" are in compliance with: Approx.
(Original instructions) ENGLISH Guarantee Black & Decker is confident of the quality of its products and offers consumers a 24 month guarantee from the date of purchase. This guarantee is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
ENGLISH 10 (Original instructions)
(Original instructions) ENGLISH 11
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 Tel. Fax 03-8720 5100 03-9727 5940 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Aukland 1060 Tel. Fax +64 9 259 1133 +64 9 259 1122 United Kingdom & Black & Decker Tel. 01753 511234 Republic Of Ireland 210 Bath Road Fax 01753 512365 www.blackanddecker.co.uk Slough, Berkshire SL1 3YD emeaservice@sbdinc.
