2 3 1 4 5 www.blackanddecker.co.
ENGLISH (Original instructions) 4 6 5 A 3 B 2 4 1 C 5 6 10 11 E 2 D
(Original instructions) Intended use Your BLACK+DECKER BDCD12 - Drill, has been designed for screwdriving applications and for drilling in wood, metal and plastics. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference.
ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g. Use the power tool, accessories and tool bits etc.
(Original instructions) Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated.
ENGLISH (Original instructions) Warning! Do not use tool while it is connected to the charger. Warning! fire Hazard. When disconnecting the charger from the tool, be sure to unplug the charger from the outlet first, then disconnect the charger cord from the tool. Installing and removing the battery pack from the tool (fig. B) Warning! Make certain the lock-off button is engaged to prevent switch actuation before removing or installing battery.
(Original instructions) Troubleshooting Problem Possible cause Possible solution Unit will not start. Battery pack not charged. Check battery pack charging requirements Battery pack will not charge. Charger not plugged in. Plug charger into a working outlet. Surrounding air temperature too hot or too cold. Move charger and battery pack to a surrounding air temperature of above 40 degrees F (45ºC) or below 105 degrees F (+40.5ºC) Battery pack has reached its maximum thermal limit.
(Original instructions) ENGLISH Technical data EC declaration of conformity BDCD12 Voltage VDC 10.8 No-load speed Min-1 0-550rpm Max. torque Nm 26 Chuck capacity mm 1-10 BDCD12 - Drill, Screwdriver Max Drilling capacity Steel/wood mm 10/25 Weight kg 0.93 Charger Black & Decker declares that these products described under "technical data" are in compliance with: 90621477 Input voltage VAC 230 Output voltage VDC 10.8 Current mA 200mA Approx.
(Original instructions) ENGLISH Guarantee Black & Decker is confident of the quality of its products and offers an outstanding guarantee. This guarantee statement is in addition to and in no way prejudices your statutory rights. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area.
ENGLISH 10 (Original instructions)
(Original instructions) ENGLISH 11
Australia Black & Decker (Australia) Pty. Ltd. 20 Fletcher Road, Mooroolbark, Victoria, 3138 Tel. Fax 03-8720 5100 03-9727 5940 New Zealand Black & Decker 5 Te Apunga Place Mt Wellington Aukland 1060 Tel. Fax +64 9 259 1133 +64 9 259 1122 United Kingdom & Black & Decker Tel. 01753 511234 Republic Of Ireland 210 Bath Road Fax 01753 512365 www.blackanddecker.co.uk Slough, Berkshire SL1 3YD emeaservice@sbdinc.
