User Manual

ENGLISH
AIR CONDITIONER FEATURES
WARNING: To reduce the risk of re. electric shock, or injury to persons, read
the IMPORTANT SAFETY INSTRUCTIONS before operating this
appliance.
CAUTION: Please always wait 3 minutes when turning unit off then on again,
and when changing from cool to fan and back to cool. This prevents
compressor from overheating & possible circuit breaker tripping.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable air ow(see Air Directional Louvers).
4. Once the root has cooled, adjust the thermostat to the setting you nd most
comfortable.
5. Make sure that the air ow inside and outside are not obstructed by anything.
AIR DIRECTIONAL LOUVERS
The louvers will allow you to direct the air ow Up or Down(on some models)
and Left or Right throughout the room as needed. Pivot horizontal louvers until
the desired Up/Down direction is obtained. Move the Lever(s) from side to side
until the desired Left/Right direction is obtained.
FRESH AIR VENT CONTROL
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig. A)
2. Draw fresh air into the room- Vent Open (see Fig. B)
3. Exchange air from the room and draws fresh air into the room - Vent and
Exhaust Open. (see Fig. C)
SET UP & USE
Lever sLevers Levers
Page 14
Fig. A(VENT CLOSED)
Fig. B(VENT OPEN)
Fig. C(VENT & CXHAUST OPEN)