User Manual

8
ENGLISH
(Original instructions)
u Move charger and battery pack to a location where the
surrounding air temperature is approximately 18°- 24°C
u If charging problems persist, take the tool, battery pack.
and charger to your local service centre.
u The battery pack should be recharged when it fails to
producesufcientpoweronjobswhichwereeasilydone
previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with no
adverse affect on the battery pack.
u Foreign materials of a conductive nature such as,
but not limited to, steel wool, aluminium foil, or any
buildup of metallic particles should be kept away from
charger cavities.
Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug charger
before attempting to clean.
u Do not freeze or immerse charger in water or any
other liquid.
Warning! Do not allow any liquid to get inside charger. Never
attempt to open the battery pack for any reason. If the plastic
housing of the battery pack breaks or cracks, return to a
service centre for recycling.
Installing and removing the battery (Fig. B)
Warning! Make certain the vac is switched off before
removing or installing battery.
To install battery pack
u Insert battery pack (5) into the vac until an audible click is
heard (Figure B). Make sure battery pack is fully seated
and fully latched into position.
To remove battery pack
u Depress the battery release button (6) as shown in
Figure B and pull battery pack out of the vac.
Operation
Warning! This product is for dry pick-up only.
u To switch the vac on, slide the on/off switch (1) forward
(Fig. C).
u To switch the vac off, slide the on/off switch (1) backward
(Fig. C).
Mounting accessories (Fig. D)
u The brush tool (8) has a brush that can be used for
dusting and upholstery cleaning.
u The crevice tool (7) allows for vacuuming in narrow and
hard to-reach places.
u To attach an accessory, press the accessory into dust
bowl (3).
u Crevice tool can be stored on the unit as shown in (7a).
Removing dust bowl (Fig. E)
u Remove the dust bowl (3) by pressing the dust bowl
release button (2) and pulling the bowl down and out
(Fig. E).
Removing lters (Fig. F, G, H and I)
Afteryouhavereleasedthebowlfromtheunitthelteris
inside bowl.
u Removethelterfromthebowlbypullingthelterout.
u Dispose of the dirt inside.
u Theprelter(4a)andlter(4)arettedtogether.
u Youmusttwistthepreltertoreleasefromthelterto
allow you to clean each part separately as shown in
gureH.
Cleaning the product
Dispose of the dirt inside the dust bowl (3) as shown in
gureG.Thedustbowlcanberinsedbywater.Howeverit
needs to be dried afterwards.
Warning! Never use this cordless hand vacuum
withoutitslters.
Note:Thelterisre-usable,donotconfusethemwith
disposable dust bags, and do not throw it away when the
productisemptied.Werecommendthatyoureplacethelter
every 6-9 months.
Warning! Maximum dust collection will only be obtained with
cleanltersandanemptydustbowl.Ifdustbeginstofallback
out of the product after it is switched off, this indicates that the
bowl is full and requires emptying.
u Removethelter(4)andshakeorlightlybrushanyloose
dustoffthelter.
u Empty the dust from the bowl and wash if necessary.
u Washthelterregularlyusingwarm,soapywateras
showningureI.Ensurethatitiscompletelydrybefore
using again.
Note:Thecleanerthelteris,thebettertheproduct
will perform.
u The dust bowl can also be washed in warm soapy water.
Ensure that it is dry before re-attaching.
u Never immerse the product in water. A damp cloth and
soapy water should be used to clean the exterior of the
motor section. Always ensure the product is completely
dry before re-use or storing.