User Manual

7
ENGLISH
(Original instructions)
:
Warning!Toreducetheriskofinjury,theuser
must read the instruction manual.
f
Wear ear protectors with impact drills.
Exposure to noise can cause hearing loss.
Do not stare at operating lamp
Additional safety instructions for batteries and
chargers
Batteries
● Never attempt to open for any reason.
● Do not expose the battery to water.
● Do not expose the battery to heat.
● Do not store in locations where the temperature may
exceed 40 °C.
● Charge only at ambient temperatures between 10 °C and
40 °C.
● Charge only using the charger provided with the appli-
ance/tool.
● When disposing of batteries, follow the instructions given
in the section “Protecting the environment”.
● Donotdamage/deformthebatterypackeitherbypuncture
orimpact,asthismaycreateariskofinjuryandre.
● Do not charge damaged batteries.
● Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries carefully wipe the
liquid off using a cloth. Avoid skin contact.
● In case of skin or eye contact, follow the instructions
below.
@
Warning!Thebatteryuidmaycausepersonal
injuryordamagetoproperty.Incaseofskincontact,
immediately rinse with water. If redness, pain or ir-
ritation occurs seek medical attention. In case of eye
contact, rinse immediately with clean water and seek
medical attention.
Chargers
Yourchargerhasbeendesignedforaspecicvoltage.Always
check that the mains voltage corresponds to the voltage on
the rating plate.
@
Warning! Never attempt to replace the charger unit
with a regular mains plug.
● Use your charger only to charge the battery in the tool with
which it was supplied. Other batteries could burst, causing
personalinjuryanddamage.
● Never attempt to charge non-rechargeable batteries.
● If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Service Centre in order to
avoid a hazard.
● Have defective cords replaced immediately.
● Do not expose the charger to water.
● Do not open the charger.
● Do not probe the charger.
● Theappliance/tool/batterymustbeplacedinawellventi-
lated area when charging.
$
The charger is intended for indoor use only.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
 2.Forward/reverseslider
 3.Torqueadjustmentcollar
4. Keyless chuck
5. Dual range gearing
6. LED work light
7. Battery
8. Battery release button
Assembly
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (g. A1, A2)
Thebatteryneedstobechargedbeforerstuseandwhenev-
eritfailstoproducesufcientpoweronjobsthatwereeasily
done before. The battery may become warm while charging;
this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging tem-
perature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell tempera-
ture warms up or cools down.
u Plug the charger (9) into any standard 230 Volts 50 Hz
electrical outlet.