Advertencia: Léase este instructivo antes de usar el producto. Warning: Read instruction manual before using product.
?
KG915 Voltaje AR, B2C, B2 Voltaje B3, BR 220V 120V/127V 5/8"-11 / M14
ENGLISH ANGLE GRINDER KG915 CONGRATULATIONS! You have chosen a Black & Decker tool. Our aim is to provide quality tools at an affordable price. We hope that you will enjoy using this tool for many years. INTENDED USE Your Black & Decker angle grinder has been designed for cutting metal and masonry using the appropriate type of cutting or grinding disc. It is also suitable for sanding using a backing pad and sanding disc. This tool is intended for consumer use only.
ENGLISH General 1. Keep work area clean Cluttered areas and benches can cause accidents. 2. Consider work area environment Do not expose the tool to rain. Do not use the tool in damp or wet conditions. Keep the work area well lit. Do not use the tool where there is a risk of causing fire or explosion, e.g. in the presence of flammable liquids and gases. 3. Keep children away Do not allow children, visitors or animals to come near the work area or to touch the tool or mains cable. 4.
ENGLISH Keep handles and switches dry, clean and free from oil and grease. 20. Repairs This tool complies with relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts; otherwise this may result in considerable danger to the user. Additional safety instructions for angle grinders - Do not let children or pregnant women enter the work area. - Do not eat, drink or smoke in the work area. - Dispose of dust particles and any other debris safely.
ENGLISH ASSEMBLY Before attempting any of the following operations, make sure that the tool is switched off and unplugged and that the disc has stopped rotating. Removing and refitting of the guard Never use the tool without the guard, except when sanding. Removing (fig. B) This tool is fitted with a guard. For sanding only, you can remove the guard as follows. Remove the outer flange, disc and inner flange as described below. Use a screwdriver to remove the screws (6).
ENGLISH Fitting Remove the guard as described above. Place the inner flange (12) onto the spindle (9) as shown (fig. H). Make sure that the flange is correctly located on the flat sides of the spindle. Place the backing pad (16) onto the spindle. Place the sanding disc (17) onto the backing pad. Place the outer flange (14) onto the spindle with the raised centre facing away from the disc. Keep the spindle lock (3) depressed and tighten the outer flange using the two-pin spanner (15) (fig. A & I).
Solamente para propósito de Argentina: Importado por: Black & Decker Argentina S.A. Pacheco Trade Center Colectora Este de Ruta Panamericana Km. 32.0 El Talar de Pacheco Partido de Tigre Buenos Aires (B1618FBQ) República de Argentina No. de Importador: 1146/66 Tel. (011) 4726-4400 Imported by/Importado por: Black & Decker do Brasil Ltda. Rod. BR 050, s/n° - Km 167 Dist. Industrial II Uberaba ˆ MG ˆ Cep: 38064-750 CNPJ: 53.296.273/0001-91 Insc. Est.: 701.948.711.00-98 S.A.C.
