Operating Guide

MAINTENANCE
PWASH20 20 Gallon Parts Washer Assembly & Operating Instructions
9
wer supply before cleaning. Wear safety eyewear before cleaning.
Disconnect the po
A qualified repair technician must perform any tool service or repair. Service or mainte
nance
performed by unqualified personnel could result in injury. Use only identical replacement parts. Use of
structions may create a risk of electric shock or
unauthorized parts or failure to follow maintenance in
injury.
Do not
make contact with a grounded surface while using this power tool. Contact with surfaces like
pipes, radiators or major appliances increase your risk of electric shock.
Warning: Always unplug the Power Cord from the electrical outlet before performing any maintenance.
. Replace the cleaning solution when it becomes dirty.
. Place an empty container on the lower Shelf that is large enough to hold all of the liquid which is
id should drain into the empty container on
the used cleaning solution properly. Do not drain the cleaning solution into the street drains,
thods.
ug then refill the Body with new cleaning solution.
cessary to clean the
lexible Pipe (24).
t the indicator light on the Switch Box is on.
. Turn the Switch to the OFF position.
l outlet.
pect its interior for debris. Use compressed air to
e Screws, then clear and remove any foreign matter
e Flexible Pipe to the Elbow, and replace the Pump Housing Cover.
hat are recommended by the manufacturer for your model. Accessories that may be suitable
hazardous when used on another tool.
the amount of current
ive voltage drop or overheating.
Replacing Cleaning Solution
1
2
in the Body.
3. Remove the Plug from the bottom of the Body. The flu
the Shelf below.
4. Dispose of
house drains, or into the earth. Contact your local waste management officials for proper disposal me
5. Replace the Pl
When the cleaning solution flow is reduced or stopped, it may be ne
F
Cleaning the Flexible Pipe and Impeller
1. Make certain tha
2
3. Unplug the Power Cord from the electrica
4. Remove the Flexible Pipe from the Elbow. Drain the pipe, ins
blow clean.
5. Remove the Pump Housing Cover by removing th
from the impeller.
6. Reattach th
ACCESSORIES
Use only accessories t
for one tool may become
Always attach grounded (3-prong) extension cords to grounded (3-prong) outlets.
you must use an extension cord, be sure that the gauge is large enough to carry
If
necessary for your power tool. If not, your tool may experience a loss of power, excess
or example, the smaller the gauge number, the heavier the cord.
F