Full Product Manual

PWASH20 20 Gallon Parts Washer Assembly & Operating Instructions

FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE

IMPORTANT SAFETY RULES

COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT.

THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR.

Keep your work area clean and well lit. Cluttered work benches and dark work areas may cause

accidents or injury.

Do not operate the

parts washer in explosive areas, such as in the presence of flammable liquids,

gases or dust. Power tools create sparks which may ignite the dust or fumes.

Keep bystanders, children and visitors away while operating the parts washer. Distractions can

cause you to lose control.

Double insulated tools are equipped with a polarized plug (one blade is wider than the other.) This

plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the

plug. If it still does not fit, contact a qualified electrician to install a polarized outlet. Do not change

the plug in any way. Double insulation eliminates the need for the three wire grounded power cord and

grounded power supply system.

Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.

There is an increased risk of electric shock if your body is grounded.

Do not abuse the cord. Never use the cord to carry the tool or pull the plug from an outlet. Keep

the cord away from heat, oil, sharp edges, or moving parts. Replace damaged cords immediately.

Damaged cords increase the risk of electric shock.

When operating the tool outside, use an outdoor extension cord marked “WA” or “W.” These cords

are rated for outdoor use and reduce the risk of electric shock. Make sure the extension cord being used

is in good condition. If there are any cuts or nicks (no matter how deep) in the insulation, DO NOT use

that cord. Also, make sure the extension cord is heavy enough to carry the current needed. DO NOT use

small "around-the-house” lamp extension cords. These cords can easily overheat and/or catch fire when

used with power tools.

Do not force tool. Use the correct tool for your application. The correct tool will do the job better and

safer at the rate for which it is designed.

Do not use the

parts washer if the power switch does not turn it “ON” or “OFF”. Any tool that

cannot be controlled with the switch is dangerous and must be repaired.

Disconnect the power cord plug from the power source before making any adjustments, changing

accessories or storing the tool. Such preventive safety measures reduce the risk of starting the tool

accidentally.

Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the

hands of untrained users.