Use and Care Manual

PWASH35 3.5 Gallon Parts Washer
3
3.5 Gallon Parts Washer PWASH35 Assembly and Operating Instructions
5 Gallon Tank Capacity / 3.5 Gallon Solvent Capacity
Black Powder Coat Paint Finish / Heavy-Duty Steel Construction
120 Volts / 60 Hz Water Pump
Fusible Link Arm & Steel Lid
Max. Pump Output: 22 GPH flow rate (with flexible pipe)
Max. Pump Output: 210 GPH flow rate (without flexible pipe)
Recirculates .3 GPM of Solvent
Removable Shelf With Drainage Holes Keeps Parts Out Of Solvent During Inspection and Drying.
Flexible Chrome Plated Nozzle Adjusts For Full Coverage
WARNING Read carefully before operating.
1. Do not over fill solvent. Fill to just below level of parts tray.
2. Do not use any solvent with a flashpoint below 150° F.
3. Only use petroleum or biodegradable based solvents that are approved for electric parts washers.
4. Use only in a well ventilated area.
5. Do not operate while smoking
6. Do not operate near heat sources such as heaters, sparks, open flame, etc.
7. Should fire occur in parts washer do not attempt to move parts washer
8. Lid is on a fusible link and will fall automatically to extinguish flame.
9. Do not modify or jam lid to keep lid locked in an open position.
10. Replace damaged parts immediately.
11. Use only on grounded 115Volt, 60Hz, outlet.