Specifications

724-746-5500 | blackbox.com
Page 15
5.2 Ethernet
Here in the first register you can define the IP address, the subnet mask and
the gateway. You can also allocate an IP address from the network by
activating the DHCP checkbox. Prior to activation, make sure a DHCP server
is present in the network. Two DNS server addresses can also be defined.
For easier identification you can also assign a name to the device and
designate a caption.
The default name is “rioxo_0” and the default caption is “e.q. blu-ray player”.
After entering the network data, define the system operating mode of the
device – either as receiver or transmitter – by marking the checkbox
accordingly.
To distinguish between several VX-HDV-IP devices in a rack, activate
“Identify device”.
All the LEDs in the device you want to identify will then flash red.
Press the “Apply” key to confirm and activate your changes. If everything
works correctly, press “Save” to finalize all changes.
This ensures that your new settings will still be active after a reboot.
Press “Undo” to cancel a command without saving.