Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
9 ND_NO Non Urgent-Alarm contact, normally open For Mini-Rack units
11.3 Ethernet (10BaseT) connector
Type: RJ-45
Pin Description
1 Tx+
2 Tx-
3 Rx+
4 NC
5 NC
6 Rx-
7 NC
8 NC
18
............
RJ45
11.4 Power connector (For MDS922AE-10BT)
Type: Molex, 4 pin
43
12
Pin Signal Description
1 -PWR negative power supply terminal
2 PROT Grounding
3 NC –
4 +PWR positive power supply terminal
Version: 1.0 Page. 85 of 95