Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
Parameter:
all: Deletes all routes from the table.
number: Deletes the route with the number
displayed by the show command.
8.3.15.3 Show command
The show command displays the routing table.
> rtable> show
Routing Table:
No. Destination IP SubMask Gateway IP
1 0.0.0.0 0.0.0.0 216.71.89.3
2 198.24.67.0 255.255.255.0 216.71.89.3
effective routing table:
Routing table is empty
> rtable>
Command format: show
Parameter:
No: The routing number.
Destination IP: Destination address.
SubMask Subnet mask
Gateway IP Gateway IP address
8.3.16 Save command
See 8.2.12
8.3.17 Shdsl command
See 8.2.13
8.3.18 Show command
See 8.2.14
8.3.19 Ver command
See 8.2.15
Version: 1.0 Page. 78 of 95