Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
8.3.12 R1483 command
The r1484 command puts the system into the menu of RFC1483 encapsulation settings.
>> r1483
> r1483>
Command format: r1483 [delwanip <all>|[<vpi>/]<vci> | setqos [<vpi>/]<vci> <ubr|cbr|vbr(nrt)> |
setrip [<vpi>/]<vci> <1|2|1&2|0> | setwanip setwanip [<vpi>/]<vci> <wanip[/<masknum>]>
[llc/vcmux] | show]
Parameter:
Delwanip: See 8.3.12.1
Setqos: See 8.3.12.2
Setrip: See 8.3.12.3
Setwanip: See 8.3.12.4
Show:
See 8.3.12.5.
8.3.12.1 Delwanip command
The delwanip command serves to delete all or selected PVC.
> r1483> delwanip all
> r1483>
Command format: delwanip <all>|[<vpi>/]<vci>
Parameter:
All: Deletes all PVC.
VPI/VCI: Deletes the selected PVC with the
VPI/VCI number.
8.3.12.2 Setqos command
The setqos command sets the priority for the active PVC.
> r1483> setqos 8/35 ubr
> r1483>
Command format: setqos [<vpi>/]<vci> <ubr|cbr|vbr(nrt)>
Version: 1.0 Page. 74 of 95