Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
8.3.10.4 Echo command
The echo command enables and disables the LCP response (the process of the control
connection). LCP is used to confirm the established PPP connection, the interval time between
the LCP responses can be changed.
> pppoa> echo 120
> pppoa>
Command format: echo <interval time>
Parameter:
Interval
time
Intervals between LCP responses. The interval
lies in the range from 0 to 65535 seconds. The
default setting is 60 s. If the parameter is
0, the function is disabled.
8.3.10.5 Setllc command
The setllc command enables and disables the logical connection control.
> pppoa> setllc enable
> pppoa>
Command format: setllc <e>nable|<d>isable
Parameter:
<e>nable|
<d>isable
The function of logical connection control
(enabled/disabled).
8.3.10.6 Setqos command
The setqos command sets the priority for the active connection of PPP over ATM.
> pppoa> setqos ubr
> pppoa>
Command format: setqos <ubr|cbr>
Parameter:
UBR: Sets the UBR priority.
CBR: Sets the CBR priority.
Version: 1.0 Page. 72 of 95