Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
> lan>
Command format: setdhcp [server|disable]
Parameter:
Ethernet ip: Ethernet interface IP address.
Subnet mask: Ethernet interface subnet mask.
DHCP current
setting :
DHCP server current settings.
DHCP ineffective
setting :
DHCP server settings (server/disable).
8.3.5 List command
See 8.2.5
8.3.6 Manage command
See 8.2.6
8.3.7 Mode command
See 8.2.7
8.3.8 Pat command
The pat command puts the system into the menu of NAT address translations settings.
>> pat
> pat>
Command format: pat [addpatin | delpatin | setpat | show]
Parameter:
addpatin: See 8.3.8.1
delpatin: See 8.3.8.2
setpat: See 8.3.8.3
Show: See 8.3.8.4
8.3.8.1 Addpatin command
The addpatin command is used to translate private IP addresses into real in order to provide
access to LAN resources from WAN.
> pat> addpatin pppoa 434 udp 192.168.2.134
> pat>
Version: 1.0 Page. 68 of 95