Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
8.3.3 Ipoa command
The ipoa command puts the system into the menu of connection settings of IP over ATM.
>> ipoa
> ipoa>
Command format: ipoa [delwanip | setqos | setrip | show]
Parameter:
Delwanip: See 8.3.3.1
Setqos: See 8.3.3.2
Setrip: See 8.3.3.3
Show: See 8.3.3.3
8.3.3.1 Delwanip command
The delwanip command serves to delete all or selected PVC.
> ipoa> delwanip all
Command format: delwanip <all>|[<vpi>/]<vci>
Parameter:
All: Deletes all PVCs.
VPI/VCI: Deletes the selected PVC with the VPI/VCI number.
8.3.3.2 Setqos command
The setqos command sets the priority for the active PVC.
> r1483> setqos 8/35 ubr
> r1483>
Command format: setqos [<vpi>/]<vci> <ubr|cbr|vbr(nrt)>
Parameter:
VPI/VCI: Sets PVC with the VPI/VCI number.
UBR: Sets the UBR priority.
CBR: Sets the CBR priority.
VBR: Sets the VBR priority.
VBRNRT: Sets the VBR-NRT priority.
Version: 1.0 Page. 64 of 95