Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
Command formate: dnsrelay [setdnsip <dnsip> [<retry times>] | show]
Parameter:
Setdnsip: See 8.3.2.1
Show: See 8.3.2.2
8.3.2.1 Setdnsip command
The setdnsip command sets the DNS-server address.
> dnsrelay> setdnsip 10.0.0.50 3
Command format: dnsrelay [setdnsip <dnsip> [<retry times>]
Parameter:
Dnsip: IP address of the DNS server
Retry
times:
The number of retry connections with the server
8.3.2.2 Show command
The show command displays the DNS current settings and server connection status.
> dnsrelay> show
DNS server ip: 0.0.0.0
Retry times: 3
DNS relay status
DNS server address discovery incomplete.
> dnsrelay>
Command format: show
Parameter:
None
Version: 1.0 Page. 63 of 95