Ethernet Router / BridgeUser Manual Version 1.0
Table Of Contents
- VERSION CONTROL
- INTRODUCTION
- SPECIFICATION
- TECHNOLOGIES
- DESCRIPTION OF THE DEVICE
- MECHANIC DESIGN
- EQUIPMENT INSTALLATION
- PROGRAMMING GUIDE
- Introduction
- Main menu of the bridge mode
- Main menu of the router mode
- FIRMWARE LOADING
- TECHNICAL SPECIFICATIONS
- CONNECTORS’ DESCRIPTION
- DESCRIPTION OF INTERFACE CABLES
- DELIVERY SET
- GLOSSARY
- EXAMPLE OF NETWORK CONFIGURATION
Stand Alone
From the constructive point of view, MDS921AE-10BT represents a case made of shockproof
polystyrene to withstand harsh environmental conditions and containing the basic elements of the
device. The power supply unit represents an external power supply unit in the form of a plug.
The panels have the following sockets and LEDs:
LED Description
Alarm Alarm LED
Sync xDSL line status LED
Link User’s Ethernet interface status LED
Act Transmission status LED over user interface
Pwr Power supply LED
xDSL RJ11 socket to link DSL lines
10BaseT four RJ45 sockets to link Ethernet network
1, 2, 3, 4 Hub port activation LED
Col Collision LED in Ethernet interface
DС/IN External power adapter entrance socket
Monitor DB9F socket to connect management terminal
┴ Grounding bolt
Fig. 18 MDS921AE-10BT rear panels
Version: 1.0 Page. 40 of 95