User`s guide

CHAPTER 6: The Status Screens
73
• Status: The status for each TCP port.
■
If the Status Column reads “Active,” this indicates the port has accessed
command mode.
■
If this Telnet session is connected to an RS232 Port, this column will read
“C-nn,” where “nn” indicates the connected port for each Telnet session.
• Username: The username that was entered at this port in order to access
command mode.
6.4. The Port Parameters Screens (/W)
The /W (Who) command displays more detailed information about an individual
Secure Site Manager port. Rather than listing general connection information for all
ports, the Port Parameters screen lists all defined parameters for a specific port.
The Port Parameters Screens are available to accounts that permit Supervisor
commands and accounts that do not permit Supervisor commands. Note however,
that if your account that does not permit Supervisor commands, the Secure Site
Manager will only display information for the port from which you have logged in.
The /W command can be applied to either an RS232 Port or the Network Port.
Figure 6-4 shows the screen displayed when the /W command is applied to an
RS232 Port, and Figure 6-5 shows the screen displayed when an account that permits
Supervisor commands applies the /W command to the Network Port.