Technical data

8 User’s and Service Guide
87050A Option K22 Getting Started
Getting Started
Connecting and Turning on the Test Set
The test set is designed to be placed underneath the network ana6lyzer in a rack system
and connected to it as shown in Figure 5. Use the two SMA 50 Ω jumper cables
(08720-20245) that were shipped with the test set. See Table 1 on page 2.
Figure 5 Connecting the Test Set to the Network Analyzer
After all the proper connections have been made, turn on the test set using the front panel
line switch. Refer to Figure 12 on page 43.
NOTE For accurate, repeatable measurements, be sure to let the test set warm up
for at least 2 hours. It is recommended that the test set not be turned off on a
regular basis. For the most stable and accurate measurements, leave the test
set turned on at all times.