Specifications

28
SERVSWITCH WIZARD PRO
5. Operation
This chapter explains the general operation of the ServSwitch Wizard Pro. We
recommend that you read this chapter carefully before starting to use the Switch;
also make sure you have read the important note on page 19.
5.1 Power Status
At power-up, the ServSwitch Wizard Pro will try to select CPU channel #1 unless
(a) a password has been set or (b) the Switch isn’t getting enough power to
operate properly. Watch the Switch’s front-panel 7-segment display, as described
in Figure 5-1 below: If the Switch is not receiving enough power, the display will be
blank or show “o”; if the Switch can select CPU 1, the display will show “1”; or if a
password has been set, the Switch will display “P” and remain locked until a valid
password is entered. (For the meaning of this display after power-up, see
Section 5.3.)
Figure 5-1. The front-panel status display at power-up.
DISPLAY SHOWS:
Blank
Flashing “o”
The number “1”
The letter “P”
MEANING:
Switch is not receiving nearly
enough power to operate
Switch is getting some power,
but still not enough to operate
Switch has powered up normally
and has selected channel 1
Switch has powered up normally
but is locked and is waiting for
the password to be entered