Specifications

19
CHAPTER 4: Configuration
4. Configuration
To configure your ServSwitch Wizard Pro system, you’ll need to configure first
the attached PCs, as directed in Section 4.1, then the Switch itself, as directed
in the rest of this chapter.
IMPORTANT NOTE
Throughout the rest of this manual, the [Enter] designation refers to the
main “enter” or “carriage-return” key (often labeled “↵”) on the main
section of the keyboard. Do not use the “Enter” key on the numeric
keypad or the extra “Enter” key found on the main section of some
specialized keyboards.
4.1 Configuring your PCs
Configure your PCs in the same way that you would if your keyboard, mouse and
monitor were all connected directly to your PCs, but keep these things in mind:
• The ServSwitch Wizard Pro emulates Microsoft compatible serial, IntelliMouse,
and PS/2 mice, so make sure that your PC software is configured for a
Microsoft mouse of the correct type. Refer to the list of supported drivers in
Section 3.1.
• The ServSwitch Wizard Pro supports VGA, SVGA, XGA, and XGA-2 type
monitors, but does not support the automatic detection features available
with some Plug-and-Play monitors and video cards. If you have this type of
video card or monitor, you should select the video mode manually instead
of relying on the automatic detection feature.