Computer Hardware User Manual

Page 160
724-746-5500 | blackbox.com
Chapter 5: Operation
5.7.2 Reset
Use the OSD to reset the extender:
Figure 5-12. OSD icon.
CAUTION: If you do a factory reset, all current settings and all configurations
stored in the matrix will be lost. This also applies to the network
parameters (reset to DHCP) and the admin password.
NOTE: If a firmware update has been done since the delivery, the matrix will be
set to the state defined there.
OSD
1. Select “Configuration > Reset Matrix” in the main menu.
2. To confirm the selection, press the “Yes” button.
The ServSwitch DKM FX will be reset to the factory settings.
5.7.3 Power Down
Slide the on and off switch at the main sockets of the power supply units to start
or switch off the matrix.