Installation guide

48
SERVSWITCH™ ULTRA
4.3.12 A CTIVATE O N -S CREEN M ENUS
You can use this command to cause the ServSwitch Ultra to display its on-screen
overlay menus, beginning with the main menu (see Section 5.1.1). To issue the
Activate On-Screen Menus command, press and release the left Control key, then
press and release the [F12] key.
4.3.13 A CTIVATE S ELECT W INDOW
You can use this command to cause the ServSwitch Ultra to display its “computer
select window” (see Section 5.5). To issue the Activate Select Window command,
press and release the left Control key, then press and release the [ESC] (escape) key.
4.3.14 L
OG O UT
If an access password has been set for your ServSwitch Ultra system (see
Section 5.5.2), you can use this command to log out (to relinquish access rights)
when you’re finished with a session at a user station. This will cause the ServSwitch
Ultra to display an “Enter password” prompt and stop accepting any keyboard and
mouse input except the access password; a few seconds later, it will blank the
screen with the currently selected screen saver. While no one is logged in—that is,
until someone correctly enters the access password—typing at the keyboard will
cause the “Enter password” prompt to briefly become visible, but otherwise, no
computer video will be displayed and no keyboard and mouse access will be
allowed.
If no access password has been set for your system, you can use this command to
cause the ServSwitch Ultra to display its currently selected screen saver (see
Section 5.4.1.C). Normal video will be restored as soon as someone types at the
keyboard or moves the mouse.
To log out,
press and release the left Control key, then type [L].