Installation guide

18
SERVSWITCH™ ULTRA
2.4 The Rear Panel
All cable connections are made at the rear panel of the ServSwitch Ultra, as
illustrated in Figures 2-4 and 2-5 and described below.
Figure 2-4. The rear panel of a 2 to 1 ServSwitch Ultra (KV5002MA-R2).
Figure 2-5. The rear panel of a 16 to 1 ServSwitch (SW725A-R4).
Panel Label Conn. Description
Connect your computers to these ports with “CPU
Adapter Cables.” At the ServSwitch Ultra end these
cables have a DB25 male connector; at the other
ends, they have appropriate connectors to plug into
your CPUs’ video, keyboard, and mouse ports. These
cables take the signals that would normally pass
between the CPUs’ ports and the monitor, keyboard,
and mouse, and carry them between the CPUs’ ports
and the Switch instead.
You could also connect “submaster” Serv type
switches to these ports using “ServSwitch-to-
ServSwitch Expansion Cables.” These cables have
DB25 male connectors at both ends; at the submaster
end, they should be plugged into a MONITOR/
KEYBOARD/MOUSE port. Refer to Sections 2.5 and
3.2.4.
DB25 FCPU N
[N = a number
from 1 to
either 2, 4, 8,
12, or 16,
depending on
which model
you have]
RS-232
POWER
MONITOR/KEYBOARD/MOUSE
CPU 13 CPU 14CPU 15 CPU 16
CPU 9CPU 12CPU 11 CPU 10
CPU 5 CPU 6CPU 7 CPU 8
CPU 2CPU 1CPU 4CPU 3
CPU1 CPU2 MONITOR/KEYBOARD/MOUSE RS-232
POWER
17VAC CT
CPU3 CPU4