Network Router User Manual

PQ-6 PLUS (RO)

3. Installation

The installation procedure is divided into three sections:

• Section 3.1, Initial Setup, explains how to position the PQ-6 (RO) after unpacking it, plug in the power

supply, and run off-line tests.

• Section 3.2, System Configuration and Connection, covers the considerations for setting up the PQ-6 PLUS

(RO). Items covered include setting the device address and all corresponding physical connections.

• Section 3.3, Placing the PQ-6 PLUS (RO) into Operation, details online testing procedures that you should

implement after completely installing the unit. This section also contains recovery procedures that you can

use if the PQ-6 PLUS (RO) malfunctions.

3.1 Initial Setup

3.1.1 INSTALLING A SUPPORTED PRINTER

CAUTION

Connecting a device to the DB25 connector without properly configuring the P3

jumper inside the box may cause damage to the PQ-6 PLUS (RO) and/or the attached

device.