Network Router User Manual

PQ-6 PLUS (RO)
24
SWITCH DEFINITION TABLES
Table 4-1. Option Switch SW1 Baud Rate Selection (0=OFF, 1=ON).
Switch Bank 1 Baud Rate
5678
OFF OFF OFF OFF 50
OFF OFF OFF ON 75
OFF OFF ON OFF 110
OFF OFF ON ON 134.5
OFF ON OFF OFF 150
OFF ON OFF ON 300
OFFONONOFF600
OFF ON ON ON 1200
ON OFF OFF OFF 1800
ON OFF OFF ON 2000
ON OFF ON OFF 2400
ON OFF ON ON 3600
ON ON OFF OFF 4800
ON ON OFF ON 7200
ON ON ON OFF 9600
ON ON ON ON 19200
Option Select
1 (OPT4) ON=Buffer print mode.
2 (OPT3) ON=Serial OFF=Parallel
3 (OPT2) ON=Enable Command Passthrough
OFF=Disable Command Passthrough
4 (OPT1) OFF=Use FF (Form Feed) character for page eject.
ON=Use Multiple Line Feed for page eject.
Table 4-2. Option Switch SW2.
Switch Bank 2 Position Function
1, 2 Printer type select (00=5256, 01=5224, 10=5225, 11=illegal)
3 Parallel Print option (OFF=PQ-6 responds to the busy and acknowledge
signals from the printer. ON=PQ-6 responds to the busy signal only. This
setting increases the data transfer rate to the printer.)
4 Configuration option (ON=DIP switch, OFF=Front panel)
5 Self-Test
6, 7, 8 Address select (0-6) 0=OFF, 1=ON
When the auto-feed jumper is installed in the ground position, the paper is automatically fed one line after
printing. This signal does not apply to all printers.
Jumper (J1) applies either +5 or ground or pin 14 of the Centronics printer connector.