Network Hardware User Manual

60
PRO SWITCHING SYSTEM
This section describes how to configure your system and describes the
SNMP/Telnet ASCII configuration commands. These commands are available via
the serial COMM IN or AUX ports, or via a Telnet session onto the 10BASE-T port
of the unit.
You can obtain the SNMP/Telnet ASCII configuration list of commands via the
HELP SET rack command. Almost all SET commands have a GET counterpart,
which returns the configured value.
Commands are not case-sensitive, although some command parameters such as
community names and passwords might be case-sensitive.
All settings take effect ONLY when you reset the unit.
Use the information you entered in your Rack Description Guide to properly
configure your installed racks.
To Configure your System
1. For each installed rack in your system, establish a Telnet session. The Telnet
session will simulate a terminal screen. Use the IP addresses shown on your
Rack Description Guide sheets to locate the racks.
2. When connected to the rack, press the Enter key. The unit responds with
n:OK, where n represents the assigned unit number. Communication with
the rack is not possible.
3. Using the system configuration commands on the next pages, configure each
rack with the proper settings.
4. To enable the configuration changes, reset the rack using the RESET
command. All settings take effect when the unit is reset.
Pro Switching System 10BASE-T Configuration Commands