Specifications

8. Insert the strain-relief assembly with the wire going through it into the

slot in the bottom of the modem case, and set it into the recess of the

case, as shown below for a four-wire installation:

9. Bend the top half of the MFLD’s enclosure as necessary to place it over

the strain-relief assembly, as shown below, but do not snap the case

together yet:

10. Insert one of the MFLD’s attached captive screws through its matching

saddle washer, then insert the screw and washer through the hole in the

DB25 end of the MFLD’s case. Snap that side of the case closed. Repeat

the process for the other side of the case.

11. Repeat Steps 1 through 10 for the other Multi-Function Line Driver.

Two-wire installations only: Make sure to attach the wires to the same

XMT poles on the second MFLD as on the first MFLD.

This completes the twisted-pair cable installation.

XMT G RCV

CHAPTER 4: Installation