Specifications

MULTI-FUNCTION LINE DRIVER

6. When you finish connecting the wires to the terminal block, the assembly

should look something like this (four-wire installation shown):

7. Place the two halves of the strain-relief assembly on either side of the

twisted-pair cable and press them together very lightly. Slide the assembly

so that is is about 2" (5.1 cm) from the terminal posts and press the

halves together firmly, as shown below for a four-wire installation:

If the diameter of the cable you’re using is too large or too small to fit

the assembly, call Black Box for technical support; they can give you

special quotes for strain assemblies that accomodate most cable

diameters.

XMT G RCV