Specifications

5
CHAPTER 3: Configuration
This chapter describes the locations and posssible settings of the Multi-
Function Line Driver’s DIP configuration switches, and provides detailed
instructions for setting them. Once you’ve configured the Multi-Function
Line Driver, it is designed to operate reliably and transparently, without
needing to be frequently reconfigured. Just set it and forget it!
3.1 Where the Switches Are
The Multi-Function Line Driver has two 8-position DIP switches—SW1 and
SW2—mounted on its underside, as shown in Figure 3-1 below. These
configuration switches allow you to select data rates, clocking methods, V.52
and V.54 tests, word lengths, extended signaling rates, sync or async protocol,
and 2- or 4-wire operation. As shown in Figure 3-2 on the next page, the “ON”
and “OFF” points are the same for all of the switch positions.
Figure 3-1. The MFLD’s bottom panel and configuration switches.
OFF
12345678
OFF
12345678
3. Configuration
SW1 SW2