Installation manual

3. SETTING UP THE EQUIPMENT
3-5
[Menu Units] sub menus
3.2 Menu Initial Setup
This section shows you how to set your system according to the sensors you have
connected.
Drag the main menu, then select the [Initial Setup] to show the [Menu Initial Setup] sub
menus.
Menu item Options
[Bearing Display] [True], [Magnetic]
[True Wind Calculation Ref-
erence]
[Ground], [Surface]
[Position Format] [DDD°MM.mmmm’], [DDD°MM.mmm’], [DDD°MM.mm’],
[DDD°MM’SS.ss”], [DDD.dddddd°], [Loran C], [MGRS]
[Loran C Station & GRI] [GRI] Select GRI code.
[Master] -
[First (Second) Slave] X: Upolu Point, Y: Kure Island
[Correction First (Second)
Slave]
Enter a position offset to refine Loran C
position.
[Range (Long)] [Nautical Mile], [Kilometer], [Mile]
[Range (Short)] [Foot], [Meter], [Yard]
[Short/Long Change Over] Set the distance at which to change between short and long range.
Set the long range here.
[Depth] [Foot], [Meter], [Fathom], [Passi Braza]
[Height/Length] [Foot], [Meter]
[Temperature] [Fahrenheit Degree], [Celsius Degree]
[Boat Speed] [Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[Wind Speed] [Knot], [Kilometer per Hour], [Mile per Hour], [Meter per Second]
[Atmospheric Pressure] [HectoPascal], [Millibar], [Millimeter of Mercury], [Inch of Mercury]
[Oil Pressure] [KiloPascal], [Bar], [Pound per Square Inch]
[Volume] [Gallon] (Gallon & Gallon/hour), [Liter] (Liter & Liter/hour)
[Reset Default Settings] Restore default unit settings.