Specifications

724-746-5500 | blackbox.com
Page 3
Chapter 3: Mounting the Enclosure
3. Mounting the Enclosure
You can mount the SmartPath AP (LWN602HA) within the outdoor enclosure on a variety of structures and adjust the enclosure
to a vertical orientation for optimum radio transmission. For example, you can mount the SmartPath AP enclosure to a
nonpenetrating roof stand or to a Winegard bracket, often used for mounting satellite dishes. The pole bracket is adjustable
to fit a pipe with a 1" to 3.5" (2.5 cm to 8.9 cm) diameter.
After checking that you have all the materials and tools necessary, removing the twist ties and plastic caps used to protect wires
and screws during shipping, and familiarizing yourself with the safety and site hazard warnings, you are ready to being mounting
the unit. You have a choice between mounting the SmartPath AP (LWN602HA) to a pole or to a flat surface. Both options are
described below. The major devices and accessories required for pole mounting the SmartPath AP (LWN602HA) outdoors are
shown in Figure 1.
NOTE: When mounting the Ethernet protection device inside a building, place it as close as possible to the point where the
shielded Ethernet cable enters the building and make sure the device is grounded.