Router User Guide

Dual Trunk E1 Router
Dual Trunk E1 Router User’s Guide TECHNICAL: 0118 96 56 000 25
• LOOP PAYLOAD
• LOOPUP REMOTE
• TEST PATTERN
• LOOPDOWN REMOTE
• LAMP TEST
4. Press ENTER To select the test. Press ENTER again to run the test.
Follow the display prompts to complete the test.
To Stop a Test
If you want to stop a running test, simultaneously press both the DOWN ARROW key and the UP
ARROW key on your front panel.
The Monitor Options
The Monitor category provides a means of quickly monitoring the status of your network from the
alphanumeric display. While many of the
Monitor options are read only, counters can be cleared
and reset to zero.
To reach the Monitor options:
1. Press the UP Arrow button to move among the categories until the Monitor category
appears on the display.
2. Press the ENTER button to enter Monitor mode.
UNIT STATUS appears on the display.
3. Press either the UP or DOWN Arrow to move through the monitoring options. The
Monitor options are in Table 3-4.
TERMINAL USER INTERFACE MODE
The front panel display provides miminal setup, configuration and verification menus. To fully
configure your LRU4240 router you will need to access the Terminal User Interface (TUI) directly
through the COMM port, or Telnet via the Ethernet port or the WAN ports.
Table 3-4 Monitor Options
Monitor Option Write Access
UNIT STATUS Provides timing status. Read only.
NET STATUS Loss of Signal (LOS), Loss of Frame (LOF),
NORMAL. Read only.
PPP STATUS Provide status of the PPP link.
MLPPP STATUS Provide status of the Multilink PPP link.
ETHERNET STATUS Provide status of the Ethernet interface.