Router User Guide

112 SALES: 0118 965 5100 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
4V Timezone configuration Set unit's local time. This menu works in conjunction with GMT Time Sync
menu-4T (RFC-868).
When RFC 868 is used to get time, time server provides GMT. If a unit is
deployed in different time zone user needs to configure the units
appropriately.Day light savings ends in October.
127
6A MLFR Configuration View and set the following Multilink Frame Relay configuration
parameters: Link Integrity Timer, Link Acknowledge, and Retry Counter.
127
6A PPP/MLPPP Unit
configuration
View and set PPP configuration parameters. 127
6B MFR port configuration View link status and protocol errors per link. 128
6B PPP/MLPPP Port Status View link status and protocol errors per link. 127
6Z Timeslot Configuration Fractional E1 speed configuration and port mapping to Ethernet data port.
7 Features Reserved for software feature key upgrades. 128
8 Alarm Alarm Selection submenu.
8A Alarm Configuration Allows user to enable/disable alarms and to set alarm thresholds. 128
8C Miscellaneous Management
Configuration
Dial out, passwords, alarm port settings. 129
8E Modem Initialization Strings Setting menu for modem initialization strings. 130
8F Comm port configuration Configure the comm port speed 130
8G User authentication server Configure Radius authentication protocol. See “Configuring Radius
Authentication” on page 36
36
8O Reboot the unit Rebooting the unit remotely using TUI menu
9 Diagnostics Tests and diagnostics selection menu.
9A Physical Layer Diagnostics E1 Net testing by patterns, loop, selecting loop codes on/off. 130
9B Link Layer Diagnostics Menu for In-band testing. 132
9C Delay Monitoring
Configuration
Configuration for Delay Monitoring. Results are displayed in Menu-3M. 133
$ Routing Configuration Main router configuration menu
$A Unit Routing configuration Configuration routing mode, default gateway IP address, enable Firewall,
and Load balancing.
133
$B Display routing table View routing configuration tables (static and dynamic routes) 134
$C Static routing table Configure static routes. 134
$E Routing Command Line
Interface (CLI)
Allows you to configure the dynamic routing protocols (RIP1, RIP2, and
OSPF) See “Kernel Command Reference” on page 164.
$F Display ARP Table View ARP cache table. 134
$H Firewall Table Configure access lists. 134
Table D-1 Router Menus (4 of 5)
Menu
Number
Name Description Page