Specifications

Event Logs

Alarm logs:

* Auto-learning of LMI type on link X unsuccessful

Generated when the LMI type on a link is not successfully auto-learned.

* Bad internal block checksum detected

Generated when power up diagnostics finds a fault in the internal block of the EEPROM.

* Closing remote site X (call limit)

Generated when the specified number of calls has been exceeded.

* Closing remote site X (frame relay closing)

Generated due to the frame relay protocol being disabled on the bridge/router.

* Closing remote site X (force disconnect)

Generated when the connection to a remote site is being closed due to a force disconnect.

* Closing remote site X (inactivity)

Generated when the connection to a remote site is being closed due to an inactivity timeout.

* Closing remote site X (IP triggered RIP)

Generated when the connection to a remote site is being closed due to failure of IP triggered RIP.

* Closing remote site X (IPX demand RIP)

Generated due to the failure of IPX demand RIP.

* Closing remote site X (last session)

Generated due to the termination of the last session.

* Closing remote site X (link disabled)

Generated due to the link being disabled by the operator.

* Closing remote site X (no NCPs open)

Generated when no Network Control Protocols operating.

* Closing remote site X (nonexistant)

Generated when remote site being deleted by the operator.

* Closing remote site X (not enabled)

Generated when remote site autocall being disabled by the operator.

* Closing remote site X (PVC change)

Generated due to the enabling or disabling of PPP encapsulation over frame relay.