Specifications

LDM-MR19.2

3. Standalone Installation

Follow the directions in this chapter to install the standalone version of the

LDM-MR19.2. Once you’ve done this, see Chapter 5 for operating information.

3.1 Complete Package

With your LDM-MR19.2 order, you should have received (1) LDM-MR19.2,

(1) detachable 5-ft. (1.5-m) AC power cord, and (1) copy of this manual. The

LDM-MR19.2 is fully assembled at the factory. You don’t have to assemble any

part of the unit. However, you will have to attach an appropriate plug to the

power cord if your unit is a 230-VAC (ME760AE-R2) model.

3.2 Physical Placement

Place the LDM-MR19.2 on a tabletop or bench within 5 feet (1.5 m) of a grounded

3-wire AC outlet and within 50 feet (15.2 m) of the associated data terminal. The

unit is not designed to be bolted down.

Allow at least 36 inches (90 cm) of clearance in front of the unit so you can

operate and maintain it. Be sure to leave 4 inches (10 cm) of clearance behind

the unit for signal lines and interface cables.

3.3 Data Cables

The LDM-MR19.2’s data-communication connectors (a five-crimp terminal

block and a DB25 connector) are on its rear panel (see Figure 3-1 below).

Figure 3-1. The LBM-MR19.2’s rear panel (ME760A-R2 model shown).

DTE

XMT RCV GND

115 VAC/ - 0.2A T 250V

J1 TB1