KV9612A KV9614A ServSwitch DT Series USB/DVI/Audio KVM Switches Control up to two or four PCs, or G3/G4 Mac or Mac Pro computers from a single console (USB keyboard, USB mouse, and DVI [Digital Visual Interface] monitor, plus audio). BLACK BOX ® Share two peripherals between two or four computers. Include a built-in hub. Customer Support Information Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S.
FCC and NOM Statements FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio-frequency energy, and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo, cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca, etc. 6. El aparato eléctrico debe ser usado únicamente con carritos o pedestales que sean recomendados por el fabricante. 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8.
NOM Statement 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches TRADEMARKS USED IN THIS MANUAL Black Box, the Double Diamond logo, and ServSwitch are trademarks or registered trademarks of BB Technologies, Inc. Linux is a registered trademark of Linus Torvalds. IntelliMouse, Microsoft, Windows, Windows NT, and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Mac is a registered trademark of Apple Computer, Inc.
Table of Contents Chapter Page 1. Specifications . .............................................................................................6 2. Overview . .............................................................................................7 2.1 Introduction.........................................................................................7 2.2 Features . .............................................................................................7 2.3 Components........................
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 1. Specifications Hotkeys: Yes Resolution: 1920 x 1200 @ 60 Hz Supported Operating Systems: Windows® 98 SE/Me/2000/XP, Windows Vista®, Mac® OS X, Linux® User Controls: KV9612A: (1) port button; KV9614A: (4) port buttons (labeled 1–4) also used for Scan time buttons and AutoScan, (1) function button Connectors: Both models: (1) Power; KV9612A: Console end: (1) DVI-I, (4) USB Type A, (2) 3.
Chapter 2: Overview 2. Overview 2.1 Introduction The 2- or 4-Port ServSwitch™ USB/DVI/Audio KVM Switch enables you to control up to two or four PCs, or G3/G4 Mac or Mac Pro computers from a single console (USB keyboard, USB mouse, and DVI [Digital Visual Interface] monitor, plus audio). You can use it to share two peripherals—plus a keyboard and mouse—among up to four computers. It supports Microsoft® IntelliMouse® and other mice. Setup is fast and simple, and no configuration software is needed.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 2.3 Components 2.3.1 KV9612A Front Panel Figure 2-1 shows the 2-Port ServSwitch DT Series front view. Table 2-1 describes the components numbered in the illustration. 3 2 3 2 1 Figure 2-1. The 2-Port ServSwitch DT Series front-panel view. Table 2-1. KV9612A front panel components. No. Component 1 Port selection button Press button to select a computer. 2 Port LEDs The right LEDs light to show the port that is currently selected.
Chapter 2: Overview 2.3.2 KV9612A Rear Panel Figure 2-2 shows the 2-Port ServSwitch rear view. Table 2-2 describes the components numbered in the illustration. 7 6 4 10 5 8 9 8 9 Figure 2-2. The 2-Port ServSwitch back-panel view. Table 2-2. KV9612A rear-panel components. No. Component Description 4 Power connector Connects to a 9–12-VDC, 1.5-A power supply. 5 Console USB Type A ports Keyboard and mouse ports for console. Also two ports for peripherals.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 2.3.3 KV9614A Front Panel Figure 2-3 shows the 4-Port ServSwitch DT Series front view. Table 2-3 describes the components numbered in the illustration. 3 1 4 5 2 Figure 2-3. The 4-Port ServSwitch DT Series front-panel view. Table 2-3. KV9614A front-panel components. No. Component 1, 2 Port selection buttons Press buttons 1–4 individually to select a computer.
Chapter 2: Overview 2.3.4 KV9614A Rear Panel Figure 2-4 shows the 4-Port ServSwitch rear view. Table 2-4 describes the components numbered in the illustration. 8 6 12 9 7 10 11 10 11 10 11 10 11 Figure 2-4. The 4-Port ServSwitch back-panel view. Table 2-4. KV9614A rear-panel components. No. Component Description 6 Power connector Connects to a 9–12-VDC, 1.5-A power supply. 7 Console USB Type A ports Keyboard and mouse ports for console. Also two ports for peripherals.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 2.4 What’s Included The package should contain the following items. If anything is missing or damaged, please contact Black Box. • 2- or 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switch • Universal power supply, output: 9–12 VDC, 1.5 A • Foot pad • This user’s manual 2.
Chapter 3: Installation 3. Installation PC BIOS NOTE: The following BIOS setup changes are required for PC users but not required for Mac users. 1. In STANDARD CMOS, set HALT ON ERROR to ALL BUT KEYBOARD. 2. In PNP and PCI SETUP, set PNP OS INSTALLED to YES and set USB IRQ to ENABLED. NOTE: The KV9612A and KV9614A are set to switch USB keyboard and mouse signals from one computer to another.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches 3.2 Hardware Installation This section provides instructions for the basic hardware setup of a single ServSwitch. CAUTION: Before you begin, make sure that power is turned off to all the devices that you will be connecting. To prevent damage caused by ground potential differences, make sure that all devices are properly grounded. If you don’t follow these instructions, your computers and/or the ServSwitch could be damaged. 3.2.
Chapter 3: Installation Monitor Speakers Microphone Keyboard Mouse Figure 3-2. KV9614A: console keyboard, mouse, monitor, and audio connections. NOTES: The monitor connected to the DVI-I port must be able to synchronize with the computer’s video signal. If you are uncertain about the monitor type, consult the monitor user’s manual. 3.2.2 Connecting the Computers Using the all-in-one DVI cable (EHN900024U-0006 or -0010), connect a computer to the ServSwitch.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches ServSwitch cable USB computer Figure 3-3. KV9612A: computer connection. ServSwitch cable USB computer Figure 3-4. KV9614A: computer connection. 3.2.3 Initial Power On After connecting the ServSwitch, power on the computers. The ServSwitch will get enough power to operate from the computers. Page 16 724-746-5500 | blackbox.
Chapter 4: Operation 4. Operation 4.1 Powering Up the System Once all cables have been connected and all computers have been powered on, the ServSwitch emulates mouse and keyboard signals on each port, allowing your computer to boot normally. The ServSwitch is now ready for use. 4.2 Selecting Computers Using Front-Panel Buttons You can instantly select any computer by pressing the port selection button(s) on the front panel. The corresponding LED lights when the port is selected. 4.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches Table 4-1 (continued). Hotkey commands. Key Sequence Function Left-Ctrl + Left-Ctrl + F3 To adjust Scan Rate, this command sets the duration before switching to the next computer in AutoScan. The 4-Port ServSwitch DT Series generates 1 to 4 beeps, indicating a scan interval of 3, 8, 15, and 30 seconds respectively.
Chapter 4: Operation NOTE: There are two options for USB Port Rule: ON and OFF. When set to ON, USB-Port selection follows computer selection. When set to OFF, USB-Port selection stops following USB port selection. NOTE: Make sure the USB device linking procedure has finished before switching to another computer. 4.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches P ress push button #4 one, two, three, or four times to adjust the selected port’s output emphasis. One beep = no pre-emphasis, two beeps = low preemphasis, three beeps = medium pre-emphasis, or four beeps = high preemphasis. 3. O nce the setting is finished, press the Function button one time to exit the setting. Page 20 724-746-5500 | blackbox.
Appendix: Troubleshooting Appendix. Troubleshooting A.1 Problems/Causes/Solutions Problem: The keyboard or mouse does not work. Cause #1: In AutoScan, the keyboard and mouse do not function. Solution #1: Press any front-panel button to select a computer, then use the keyboard and mouse. See Section 4.2. Cause #2: Too many keyboard or mouse drivers are installed. Solution #2: Remove all unnecessary keyboard and mouse drivers. Problem: A newly installed USB device does not work.
2- and 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switches and try again. See Sections 4.2–4.4. Problem: The computer hangs up while switching. Cause: Initializing a device takes too much time. Solution #1: Wait at least five seconds before switching the computer for proper USB communication. Solution #2: Turn off the device driver (not keyboard or mouse) before switching the computer. Problem: AutoScan does not switch a PC automatically and the ServSwitch beeps.
Appendix: Troubleshooting A.2 Calling Black Box If you determine that your 2- or 4-Port ServSwitch DT Series USB/DVI/Audio KVM Switch is malfunctioning, do not attempt to alter or repair the unit. It contains no user-serviceable parts. Contact Black Box at 724-746-5500; press 1, 2, 2. Before you do, make a record of the history of the problem. We will be able to provide more efficient and accurate assistance if you have a complete description, including: • the nature and duration of the problem.
Black Box Tech Support: FREE! Live. 24/7. Tech support the way it should be. Great tech support is just 30 seconds away at 724-746-5500 or blackbox.com. About Black Box Black Box Network Services is your source for an extensive range of networking and infrastructure products. You’ll find everything from cabinets and racks and power and surge protection products to media converters and Ethernet switches all supported by free, live 24/7 Tech support available in 30 seconds or less. © Copyright 2012.
