User manual

OEM Device Configuration Guide
revision 3 — 49
10.1.2 Establishing Network Communications:
After a factory default reset, the following changes must be made:
1. At the prompt, type:
set privileged and press <Enter>.
2. Type in the password:
system and press <Enter>.
3. Determine and set the IP address. Type:
change ipaddress [IP ADDRESS] and press <Enter>.
4. Set the Gateway. Type:
change gateway [GATEWAY] and press <Enter>.
5. Set the boot flags. Type:
change bootp disabled and press <Enter>
change dhcp disabled and press <Enter>
change rarp disabled and press <Enter>
6. Set the access type to remote. Type:
change access remote and press <Enter>
7. At the prompt, type:
logout and press <Enter>.
8. Exit from HyperTerminal and cycle power to the device.