User manual

OEM Device Configuration Guide
revision 3 — 43
9. Topaz SignatureGem Pen Tablet
The Topaz SignatureGem™ hardware is used to electronically capture cardholder signatures and connects
directly to a multimedia capture workstation via a USB or serial port.
These installation instructions and driver information are for the Topaz 1" x 5" SignatureGem USB (Z-
TS261-USB) and serial kit (Z-TS261-B).
9.1. SignatureGem Installation
The Topaz SignatureGem pen tablet can be installed on any multimedia capture workstation running
Windows 2000 or XP. It is also compatible with Citrix.
Note: Do NOT connect the signature tablet to the serial or USB port until prompted to do so.
1. Install the Wintab drivers for the Topaz SignatureGem pen tablet. You can run the Wintab15.exe file in
the Topaz SignatureGem Pen Template Driver folder on the B.A.S.I.S. ET Third Edition Disk 2 or
download the drivers from the Topaz website located at http://www.topazsystems.com/Software/
index.htm#6.
2. After the driver is installed, the PC will reboot. Connect the SignatureGem pen tablet to the correct port
(USB or serial).
3. The Found New Hardware wizard should automatically start. If it does not, manually start the wizard by
selecting Start > Settings > Control Panel > Add Hardware.
4. Complete all the steps in the Found New Hardware wizard.
5. The SignatureGem pen tablet can now be used with the B.A.S.I.S. Multimedia Capture module.
9.1.1 Load the Wintab Driver
The Wintab driver information for the pen tablet is located in the Topaz SignatureGem Pen Template
Driver folder on the B.A.S.I.S. ET Third Edition Disk 2. You can also download the driver information from
the Topaz website, located at http://www.topazsystems.com/Software/index.htm#6
.
1. Run the Wintab15.exe file located in the Topaz SignatureGem Pen Template Driver folder on the
B.A.S.I.S. ET Third Edition Disk 2.
2. The welcome screen for the Topaz 1x5 Tablet Win Tab Driver v2.12 Setup program window displays.
Click [Next].
3. The Topaz Wintab Installation window displays. Select the port the signature tablet will connect to and
click [OK].
4. Verify the Signature tablet is unplugged and click [OK].
5. The next screen explains what you should do after the driver installation is complete. Click [OK].