User manual

Receivers
30 —
revision 3
5.4. AES IntelliNet
B.A.S.I.S. integrates to the AES IntelliNet receiver when programmed to output using the Radionics 6500
output format.
The AES IntelliNet receiver can be connected to a host computer and can communicate through the
software. A direct connection can be made by making a serial connection between the host automation port
of the receiver and an available COM port on the host computer. For direct connections, the flow control
cannot be configured. This is hard-coded in the software.
For builds later than 5.10.309, the following changes are NOT needed. For build 5.10.309 and earlier, if you
are using a direct connection, a change must be made to the ACS.INI file. Make the following modification
to this file:
[Radionics6500]
DtrControl=1
Note: With this setting in the ACS.INI file, a Radionics D6600 receiver cannot be used with the 6500
output mode.
The AES IntelliNet receiver must be configured for Radionics 6500 output mode. Also note that since the
AES receiver does not have a start character, zero (0) should be used. The end character must be 0x0014. For
more detailed instructions, refer to the AES IntelliNet manual.
A LAN connection can also be made by using a 9-pin to 25-pin connector and connecting this to the
Lantronix unit. For more information, refer to IP Support.