User manual

OEM Device Configuration Guide
revision 3 — 29
You can also gather debug information when connected to the Radionics panel in 6500 or SIA modes. These
debug files can be turned on by creating a new section in the acs.ini file. These settings are as follows:
For Radionics 6500, add the following to ACS.INI
[6500]
6500Debug=1
The file generated will be “6500Debug.txt” and will be located in the logs directory.
For Radionics SIA, add the following to ACS.INI
[SIA]
SIADebug=1
The file generated will be “SIADebug.txt” and will be located in the logs directory.
For more information, refer to the Radionics Communications Receiver/Gateway manual.
5.2. Digitize 3505/3500/3000
The output format of Digitize receivers is CAPS II.
When connecting to the Digitize System, use a straight through 9-pin serial cable. Connect one end of this
cable to the computer automation port of the system.
In the back of the unit, there are four cards. The one in the upper right corner is set up to send information to
the automation software (B.A.S.I.S.). You may connect the other end of the cable either directly toa
B.A.S.I.S. server or to a Lantronix box, configuring a connection to the panel over the network.
5.2.1 Configuration
In System Administration, the panel type should be Digitize CAPS II.
The default heartbeat interval is 40 seconds and should be fine for normal use. If you find that the panel is
switching back and forth between online and offline states, increasing this value may help.
5.3. Osborne-Hoffman OH-2000
When connecting to the OH-2000, use a straight through 9-pin serial cable. Connect one end of this cable to
the computer automation port of the OH-2000. This port is located at the top left in the back of the receiver.
You may connect the other end of the cable either directly to a B.A.S.I.S. server or to a Lantronix box,
configuring a connection to the panel over the network.
Many different types of downstream devices can be used to report into the OH receiver.