User manual

OEM Device Configuration Guide

revision 3 — 23

h. Set the flush mode to 00.

i. Set the disconnect time (DisConnTime) to 00:00.

j. For SendChar 1 and SendChar 2, the values can be set to 00.

6. Select 5 for Expert Settings.

It is recommended that you set the TCP Keepalive time to 15 seconds. It is set to 0 by default. This

option specified the amount of time (during a silent connection) before attempting to check if the

network device is still online. If there is no response within this time period, the connection is dropped.

7. Select 9 to save and exit.

3.3. Downstream Devices

For any additional downstream devices supported, refer to the product user guide for wiring and

configuration.

Disable with hard disconnect 1

State LED off with connection (When there is a network

connection to or from the serial port, the state LED will turn

off instead of blink.)

Disconnect with EOT (^D) (When <Ctrl> + <D> or Hex 04

are detected, the connection is dropped. Both Telnet mode

and Disconnect with EOT must be enabled for Disconnect

with EOT to function properly. <Ctrl> + <D> will only be

detected going from the serial port to the network.)

Disconnect mode option 7 6 5 4 3 2 1 0