User manual

Intrusion Detection
22 —
revision 3
f. The remote IP address can be left at 0.0.0.0 and the remote port can be left at 0 since these are not
used.
g. The disconnect mode (DisConnMode) can be either 00 or 01. This determined the behavior of the
state LED when there is a connection.
Accept incoming with DTR 0 1 0
Accept unconditional 1 1 0
Response
Nothing (quiet) 0
Character response (C=conn,
D=disconn, N=unreachable)
1
Startup
No active startup 0 0 0 0
With any character 0 0 0 1
With active DTR 0 0 1 0
With CR (0x0D) only 0 0 1 1
Manual connection 0 1 0 0
Autostart 0101
Hostlist 0 0 1 0
Datagram type
Directed UDP 1 1 0 0
Modem mode
Full verbose 1 0 1 1 0
Without echo 0 0 1 1 0
1-character response 1 0 1 1 1
Disconnect mode option 7 6 5 4 3 2 1 0
Disconnect with DTR drop 1
Ignore DTR 0
Telnet mode and terminal type setup (The CoBox will send
“Terminal Type” upon an outgoing connection.)
1
Channel (port) password (A password is required for a
connection to the serial port from the network.)
1
Hard disconnect (The TCP connection will close even if the
remote site does not acknowledge the disconnection.)
0
Connect mode option 7 6 5 4 3 2 1 0