Specifications

C•CURE apC/L Technical Manual
Testing Readers
7-3
15. Press the 4 key. If an ARM-1 is connected, the relay should activate. Press
the 4 key again to deactivate the relay.
16. Press the 5 key to activate the card swipe test. The LEDs make no
response when the key is pressed.
17. Swipe a card in the forward direction.
The green LED lights up for 2 seconds. If the red LED lights up, there is
an error in the card read.
18. Swipe the card in the reverse direction. The amber LED lights up. If an
error is read, the red LED lights up. This only applies to magnetic stripe
readers.
19. Press the 6 key to test supervised input number 1. The LEDs indicate the
following:
Note Pressing the 4 key activates both relay outputs on an RM reader.
LED Response Condition
Green LED lights Input is in secure condition (1K)
Amber LED lights Input is in alarm condition (500Ω)
Red LED lights Input is in alarm condition (2K)
Amber LED flashes slowly Input is left open (open)
Red LED flashes rapidly Input is shorted (shorted)
Note Use resistors across the inputs to simulate the conditions listed in
the previous table.
apcl.bk Page 3 Monday, May 15, 2000 3:21 PM