Specifications

C•CURE apC/L Technical Manual
apC/L Panel Setup
6-14
Setting the Panel Address
The SW1 switch on the apC/L is a 16-position rotary switch that determines
the communication address for the panel when used with SW3:8, giving up to
32 addresses. SW3:8 must be set on or off to correctly determine the apC/L
addresses.
Each panel must have a unique address. Assign address numbers to the panels
using any convenient sequence, such as the order in which the panel are wired
to the host.
To determine an address, find the apC/L’s address (set at the host) in Table
6.7. Turn the arrow on the switch to the number in the corresponding row of
the SW1 Setting column of the following table.
Note The dialup panels cannot be set to communication address 0.
Note Table 6.7 on the next page applies only to the C•CURE 1 Plus Ultra
and the C•CURE 750.
apcl.bk Page 14 Monday, May 15, 2000 3:21 PM